If the Cisco Unified Wireless IP Phone 7925G does no boot properly, then the firmware can be recovered via the USB
connection.
1. Power on the phone while holding down the application button and the speakerphone button simultaneiously and keep
it helf until “Starting Recovery Mode” is displayed.
2. A firmware check will then be performed.
3. Insert the USB cable into the phone after USB initialization is complete.
(Ensure that the USB driver has been installed prior and that an IP in the 192.168.1.0 /24 network has been configured
for that network connection)
4. When “Web Access Available...” is displayed, then navigate to
http://192.168.1.100.
5. Browse to the TAR file, then click on “Upload”.