Привет всем. У кого то есть опыт запуска L2TP сервера для windows клиентов на ASR 1002? Мой конфиг вываливается с ошибкой
Код:
Session creation failed due to Full Virtual-Access Interfaces not being supported. Check that all applied Virtual-Template and RADIUS features support Virtual-Access sub-interfaces
Использую вот такой конфиг с локальной аутентификацией без радиуса, который на ISR работал нормально:
Код:
vpdn enable
vpdn-group L2TP
! Default L2TP VPDN group
accept-dialin
protocol l2tp
virtual-template 2
no l2tp tunnel authentication
crypto isakmp policy 20
encr 3des
authentication pre-share
group 2
lifetime 3600
crypto isakmp keepalive 3600
crypto ipsec transform-set l2tp-trset esp-3des esp-sha-hmac
mode transport
crypto dynamic-map l2tp-map 10
set nat demux
set transform-set l2tp-trset
crypto map VPN 20 ipsec-isakmp dynamic l2tp-map
interface Virtual-Template2
ip unnumbered GigabitEthernet0/0
peer default ip address pool L2TP-POOL
ppp encrypt mppe 40
ppp authentication ms-chap-v2
ip local pool L2TP-POOL 10.0.100.240 10.0.100.250
interface GigabitEthernet0/0
description External interface$ETH-WAN$$FW_OUTSIDE$
crypto map VPN